Fiesta Zetec S Ti-VCT. Colorado Red.

[Ben...]

I have this problem too. 5 centre caps and only 4 badges

[Hurst_13]

Finally....


Definetly need to get the trim done next to match.

[Hurst_13]

This is a terrible Jet Washer I found on my dad's side of the garage.
It has nothing on Ben's Karcher...


Where do you buy Snow Foam? I'll give that a go.

[Ben...]

This is a terrible Jet Washer I found on my dad's side of the garage.
It has nothing on Ben's Karcher...


Where do you buy Snow Foam? I'll give that a go.

I buy most of my stuff from http://Www.cleanyourcar.co.uk Great service, well packaged, fast delivery and reasonably priced

[Hurst_13]

Thank you!
I know you already know all this, but I am going to use Dodo's site as a guide:
http://www.dodojuice.com/dodo-juice-detailing.html

Bought a lifting kit today and a few other bits of gear.
http://www.halfords.com/webapp/wcs/stor ... yId_165727

[Ben...]

I'm half way through a full detail at the moment

My car is currently outside on axle stands lol

Took all the wheels off today; Washed, detarred, clay, polished and sealed them

They look amazing

Painted callipers and drums also

Then have got the rest of the car to do tomorrow

Going to clean engine bay
Clean all door shuts thoroughly
Then clean, detar, clay, polish and wax car

[Hurst_13]

I've had a bit of a fiddle today and managed to get the Fog Light surrounds off.
However I taking the small 'Ford' grill out it has clips on the bottom that I can't reach from the gap where I took the headlight out from. So what method did you guy take yours off with?

Here's a couple of pic's to help explain what I mean...

I've got a bit of it up either side...

[Ben...]

I think I just used a long small flat blade screwdriver to push the hidden clips

Very fiddly though!

[Hurst_13]

I had a go with a screwdriver, but I was getting a bit annoyed and thought it was best to walk away. Did you prise it up from the outside of the car, or reach from inside the bumper?

[Ben...]

Can't remember now mate

Get a torch in there.. and you can only push it one way