Page 1 of 1

Back lights

Posted: Sun Aug 12, 2012 2:34 pm
by motstrebor
How do you remove the back lights?

Re: Back lights

Posted: Sun Aug 12, 2012 8:06 pm
by Jme73
Hi,
The lights are held on by a couple of torx bolts, can't remember if its T-20 or T-25, you need to pop the rear parcel shelf out and undo the torx screws holding the panels in place in the boot. You can the get you hand up behind and fit a socket on the back of the bolts and undo them. When you put them back dont over tighten them due to the plastic!
Good luck

Jamie

Re: Back lights

Posted: Mon Aug 13, 2012 7:36 am
by Nath
As Jamie said there's 2 Torx screws on the front that need removing. But as for the back you just need to peel back the carpet enough to get your hand up and behind the light (may need to undo the screw holding the plastic that covers the top of the carpet just to give it enough slack) Once your hand is behind the light you'll feel a butterfly/wingnut you can undo with your fingers and remove the light unit.

Re: Back lights

Posted: Mon Aug 13, 2012 3:13 pm
by Jme73
Nath that sounds easier, and now in the daylight had a quick look and I got it wrong. Sorry for the wrong information.

Re: Back lights

Posted: Mon Aug 20, 2012 12:16 pm
by motstrebor
thanks guys, didnt realise there was anything underneath, wa just trying to pull out after undoing the front screws, will look tonight, thanks very much for your help! much appreciated.