Page 1 of 1
2009 Titanium - Automatic Mirror Whine
Posted: Tue May 13, 2014 2:36 pm
by Glen85
Hi folks,
I'm about to buy a 2009 3-door Titanium and I noticed, upon viewing the car, that the mirrors continue to whine once they're folded and do so for a couple of seconds after they've stopped moving. It sounds like the motors are straining. Should I investigate this, or is it a 'normal' sound to hear? If it's not, please be aware that I've never had a car with electronically folding mirrors, so I wouldn't know what I was doing with them.
Many thanks,
Glen.
Re: 2009 Titanium - Automatic Mirror Whine
Posted: Tue May 13, 2014 9:00 pm
by CarlW
I have a 2012 Titanium and the mirrors whine for a few seconds after they fold. Don't recall them doing it when new but been doing it for a while and still working fine
Re: 2009 Titanium - Automatic Mirror Whine
Posted: Wed May 14, 2014 2:57 pm
by Glen85
Hmm, ok cheers!
Re: 2009 Titanium - Automatic Mirror Whine
Posted: Sat May 17, 2014 12:03 pm
by Glen85
Hi again,
I've examined this and the mirror casing is ramming up against the sil of the window when it folds, so it definitely seems like a fault to me. It has scuffed the chrome trim on the sil and appears to be straining the motor. Can anyone advise, please?
Cheers,
Glen.
Re: 2009 Titanium - Automatic Mirror Whine
Posted: Sat Nov 06, 2021 4:49 pm
by Bits-left-over
Hello. I realise this is an old post but I have exactly the same issue - motor runs for a second or so after the mirrors have stopped moving & both mirrors rub against the chrome sills. If you fixed this, could you please let me know what you did? Is there any way to repair the scuff marks on the sills?
Thanks,
Paul
Re: 2009 Titanium - Automatic Mirror Whine
Posted: Tue Apr 11, 2023 6:41 pm
by Bits-left-over
While trying to fix a power fold issue, I removed the mirror from the door. Holding the mirror glass housing in my hand, I made power fold motor work. The motor sounded less strained since it wasn't under much load but still seemed to run for a second after the mirror & mounting stopped at their rotation limits (both directions).
As far as the mirror rubbing off the window trim, I refitted the mirror & it now doesn't rub against the trim. The mirror must've been removed at some point & put back on badly. To be fair, the mirror does have a bit of play even when the location lugs are in place. If you hold the mirror up & rotate the top of the mirror towards the front while tightening the 13mm nut, it'll be in the right position. The mirror now has about 2-3mm of clearance from the window trim when folded.