Omex install help + Dials not moving

[uuilliam]

Hey,
Firstly, I'd like to introduce myself rather than just come and ask a question straight away!

This is my Whip for now :L



It's a 1.25 (59bhp version =[ ) fiesta ofcourse.


right, the questions:

1. I have an Omex Rev Limiter + launch control - Single coil and I am trying to fit it - but need to know... where do the wires go?!

I know the red one goes to any ignition Live? The middle wire going into the coil pack ? (number 2)And I am guessing the blue one goes to the Coil A (number 1) wire ?

We tried fitting it the other day and then the car was over-fueling and was in limp mode (revs went up very slow)


2. After we disconnected all the wires from the car.
My Rev, Fuel and speedo dials don't move - they stay at 0
Any idea how I can fix this? or what may have caused it / where the wire that operates them go?


Thanks in advance for any help guys!
I seen the blue fiesta on youtube with the omex rev limiter

[uuilliam]

Right. All problems have been solved now!

Wire negative was into coil a (number 1). Live was into the centre (number 2)

Earth as standard.

The dials worked again. Not sure what I den bit they are fixed.


Only problem now is;
Setting rev limit. The lights don't show when pushing the rev limit down
The leds flash when I hold launch control in. But I don't get the rev limiting.

Anyone know any ideas?
It all looks to be working except no rev limit.